{
  "PRINT_ONE_test_plate_with_clips": {
    "size_mm": [
      23.0,
      23.0,
      15.899999618530273
    ],
    "volume_mm3": 946.1483211392082,
    "watertight": true,
    "one_solid": true
  },
  "PRINT_ONE_snap_baffle": {
    "size_mm": [
      18.700000762939453,
      18.700000762939453,
      11.5
    ],
    "volume_mm3": 1081.543738432477,
    "watertight": true,
    "one_solid": true
  },
  "WAIT_full_plate_flat_joystick_and_baffle_clips": {
    "size_mm": [
      94.0,
      94.0,
      16.899999618530273
    ],
    "volume_mm3": 16575.72233185852,
    "watertight": true,
    "one_solid": true
  },
  "nominal_LED_to_pin_keepout_gap_mm": 0.5,
  "estimated_beam_surface_strain_percent": 0.35502958579881666,
  "nominal_latch_overlap_mm": 0.35,
  "nominal_axial_play_mm": 0.1,
  "release_deflection_mm": 0.5,
  "seated_cup_overlap_mm3": 0.0,
  "locked_pull_overlap_mm3": 0.49500000000000044,
  "plate_case_overlap_mm3": 0.0,
  "neighbor_cup_gap_mm": 0.3500000000000014,
  "limits": [
    "Physical latch fit, release accessibility, fatigue, print strength and light leakage unverified.",
    "Strain number is a small-deflection beam estimate, not FEA or a material guarantee.",
    "Switch and pin envelopes are approximations; actual switch retention tabs and solder joints require a dry fit.",
    "No six-cup wiring or real LED optical test performed.",
    "Candidate full plate requires supports in the supplied face-down orientation because the joystick seats protrude on its face.",
    "Only print the TWO small test parts first; keep all older plates until fit passes."
  ]
}